|
|
Electronic Cruise Control GM07-7.074.9.1
$389.98
[info] [order]
PREWIRED & FITTED FOR THE GMC BY APPLIED GMC Per DUANE SIMMONS. SAVES TIME IN INSTALLATION. Including Rostra Actuator 250-1223, Control Unit 250-3032, Pulse Generator 250-4153 & GMC Motorhome Specific Installation Instructions ----- WE WILL BUY BACK SOME OF YOUR OLD PARTS ----- CALL US FOR DETAILS!!!!!!!
GM07-7.074.9.1
|
|
|
|
|
|
|
NO- WELD 02 SENSOR MOUNT GM12-030.17
$39.98
[info] [order]
02 SENSOR MOUNT WITHOUT WELDING---DRILL A HOLE INSTALL THE GASKET AND BOLT ON THE CLAMP!!!! IT'S JUST THAT EASY-- CLAMP IS MADE FROM 304 STAINLESS STEEL WITH HIGH CARBON STEEL HARDWARE-- GASKET IS HEAT RESISTANT TO 2500 DEGREES F
|
|
|
|
|
FI TECH 40003 FUEL COMMAND CENTER SUMP KIT AP40003
$380.00
[info] [order]
HIGHLY RECOMENDED FOR FUEL INJECTION SYSTEM--
YOUR STOCK FUEL PUMP FEEDS FUEL TO THE COMMAND CENTER WHERE AN ENCLOSED HIGH PRESSURE EFI FUEL PUMP SENDS THE FUEL ALONG TO THE EFI SYSTEM AT A REGULATED 58 PSI THE COMMAND CENTER HAS IN AND OUT PORTS ON THE TOP ALONG WITH A 0-15 PSI GAUGE THAT MONITORS INCOMING FUEL PRESSURE AND A 0-100 PSI GAUGE TO MONITOR OUTGOING PRESSURE WHICH IS REGULATED BY THE BUILT-IN FUEL PRESSURE REGULATOR AP40003
|
|
|
ATOMIC MSD FUEL INJECTION SYSTEM
$0.00
[info] [order]
UPGRADING TO EFI HAS NEVER BEEN EASIER- MSD ATOMIC IS READY TO SELF-TUNE TO YOUR ENGINE AIR/FUEL NEEDS COMES COMPLETE WITH OR WITHOUT FUEL PUMP.THIS SYSTEM WILL SUPPORT UP TO 525HP CARBURATER ADAPTER IS NEEDED SEE BELOW
GM12-MSDKIT
|
|
|
HOWELL THROTTLE FUEL INJECTION SYSTEM WITH DISTRIBUTOR HARNESS,EBL FLASH, AND ELECTRONIC DISTRIBUTOR
$0.00
[info] [order]
DESIGN FOR THE GMC MOTORHOME. PROGRAMED READY TO GO WITH SIMPLE INSTALLATION.MORE THAN 300 UNITS OUT THERE BEING USED. USES ALL GM PARTS FOR EASY ACCESS IN CASE OF FAILURE. COMES COMPLETE WITH EVERYTHING: FUEL PUMP, HOSES AND FITTINGS ETC. SPECIFICLY FOR 403/455. WILL BE PROGRAMMED TO RUN WITH OUT ANY ADJUSTMENTS. Technical assistance available 24/7
CUSTOMERS USING THIS COMPLETE SYSTEM ARE GETTING 1 TO 2 MPG IMPROVEMENT ON THEIR COACHES
CALL TO SPEAK WITH JIM K FOR MORE INFORMATION.
GM12-HOWELL
|
|
|
|
|
|
|
|
|
|
|
REAR MAIN OIL SEAL GM8-005-36
$14.76
[info] [order]
THIS SEAL WORKS BETTER THAN THE ROPE SEAL ---- INSTALL SEAL WITH FRONT LIP TOWARDS THE FRONT OF THE ENGINE.USE 3H PERMATEX SEALER BETWEEN SEAL AND MAIN CAP GROOVE--- MAKE SURE GROOVES ON CRANKSHAFT ARE POLISHED SMOOTH GM8-005-36
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
REMOTE HIGH VOLUME COOL AIR INDUCTION KITS GM12-020-2.1
$0.00
[info] [order]
3"&4" KITS WITH SPECIAL PLASTIC/RUBBER HOSE. AEM DRYFLOW FILTER ELEMENT THAT WILL FLOW HIGH VOLUME OF CLEANER AIR THAN K&N.3" HOSE AVAILABLE IN BLUE,RED,& BLACK. 4" HOSE AVAILABLE IN BLACK ONLY.AIR FILTER COMES WITH A UNIVERSAL MOUNTING BRACKET.HOSES CAN BE EXTENDED UP TO 28" IN LENGHT. THE HOSE IS MEMORY FLEX H.D. PLASTIC.
GM12-RHVCAI
|
|
|
|
|
|
|
AIR BONNET GM12-020-2.7
$169.98
[info] [order]
AIR BONNET FOR CARBURETOR/ THROTTLE BODY.
INLET 3'' DIAMETER WITH STANDARD 5 1/2'' CARBURETOR INLET. PART BRAND: TURBONETICS PART #: 10351
GM12-020-2.7
|
|
|
|
|
|
|
|
|
New Aluminum Intake Manifold 455 GM08-006-27.1
$0.00
[info] [order]
By Mondello Performance Products . There are two levels of acceptance on this item. The first is acceptance level from Mondello. The second is acceptance level from Applied GMC where the the bolt holes are deburred and surfaced. No need to raise the floor. Built-in exhaust bypass. Identical fit to original.GM08-006-27.1 It is highly recommended to use the intake manifold gasket kit with the sealant. You will need to use electric choke and special pigtail connector.
|
|
|
|
|
|
|
|
|
Rebuilt Carburetor GM12-040-31
$390.00
[info] [order]
Rebuilt Carburetor with core - by Patterson
MUST INDICATE ENGINE SIZE
Core must be rebuildrable. Core will be examined upon receipt and if it cannot be rebuilt - it will be either returned to customer at customer or destroyed. No core refund will be paid for an un-rebuildeable core. It must have the following numbers.
7043254,7045254,7045554,17057254,17057559,17058254,17058559. NO REFUND IF NUMBERS DON'T MATCH
GM12-040-31
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
OIL PAN BOLT GM8-005-52
$3.95
[info] [order]
THIS MAGNETIC DRAIN PLUG HELPS TO FILTER AND REMOVE HARMFUL METAL PARTICLES THAT ARE SUSPENDED AND CARRIED BY THE OIL DISTRIBUTION AND LUBRICATION SYSTEM IN YOUR MIGHTY GMC ENGINE. GM8-005-52
|
|
|
|
|
|
ENGINE ( OIL COOLER KIT ) GM8-012-1.7
$155.93
[info] [order]
KIT CONTAINS --- (1) 11 X 5 3/4 X 1 1/2 STACKED PLATE H/D COOLER--- (2) 90 DEG 1/2 NPT HOSE FITTINGS--( 2) CRIMPED SWIVEL INVERTED FLARE FITTINGS WITH (6 FEET) OF HIGH TEMP OIL HOSE --- CUT TO FIT--- GM8-012-1.7
|
|
|
ENGINE OIL ( COOLER ONLY ) GM8-012-1.6
$85.98
[info] [order]
RIGID "STACKED PLATE" DESIGN IS RESISTANT TO DAMAGE FROM FLYING DEBRIS 11 X 5 3/4 X 1 1/2 WITH 1/2 NPT FITTINGS ( PRESSURE TESTED TO 200 P.S.I.) AVOID GETTING METAL IN A FRESH ENGINE - BYPASS THE COOLER IN THE RADIATOR WITH THE MOST EFFICENT COOLER EVER MADE. GM8-012-1.6
|
|
|
|
|
|
|
|
|
|
|
Rebuilt Distributor GM7-031.1
$269.95
[info] [order]
SPRINGFIELD IGNITION BY DICK PATTERSON Rotor Phased Correctly to Cap
Polished Plate for Smooth Advance
New Housing Ground Terminal
Corrosion Resistant
Special Hi-Output Module
Maximum Hi-Output Coil
with rebuildable core
GM7-031.1
|
|
|
|
|
|
MSD Engine Knock Alert AP8964
$289.95
[info] [order]
Signals you to engine knock with a series of lights and an audible beep. It has a sensitivity adjustment that lets you tune it to the knocking characteristics of your coach. This device installs easily with only 3 wires to be connected.
CALL FOR PRICE!!!!
AP8964
|
|
|
Ignition Timing Control AP8965
$249.95
[info] [order]
The dash mounted ignition timing control is the perfect complement to the knock sensor because it allows you to retard or advance the ignition timing without leaving your seat.
Going over large hills is easy now. As you ascend the knock alert will indicate that the engine is knocking. You can simply reach over and retard the timing. After you reach the crest and descend the hill, you can advance your timing for more power and better fuel economy.
CALL FOR PRICE!!!
AP8965
|
|
|
|
Safeguard Knock Controller -AP8967
$595.00
[info] [order]
Universal version for distributor with single coil. Triggers from points, magnetic, Hall, or digital from ECU. Features high energy dwell control ignition, can also trigger MSD, etc. Optional dual coil driver for Porsche with twin plug distributor.
More Information
Discount may be available, call for information.
AP8967
|
|
|
Dual Monitor - AP8968
$179.00
[info] [order]
Fits 2 1/16" (52mm) gauge pod.
A built-in light sensor dims the display automatically at night, and increases brightness in direct sunlight.
A ten segment bar graph display shows amount of retard, and thus gives an indication of the engine's tendency to knock at any particular time. The monitor is connected to the J&S SafeGuard with a 3.5 mm stereo cable supplied in the kit. The new SafeGuard units have an onboard LED that glows in proportion to the amount of knock retard. This will assist you in setup of the SafeGuard, but the bargraph gives much more information.
Discount may be available, call for information.
AP8968
|
|
|
|
|
Aluminum Ram Air Scoop GM23-13
$39.00
[info] [order]
When mounted high on the driver's side front grill provides extra milage and power by allowing cool air to reach the carburetor. Connect it with a dryer hose to the tube of the air cleaner. Aluminum.
GM23-13
|
|
|
Fiberglass Ram Air Scoop GM23-16
$38.00
[info] [order]
When mounted high on the driver's side front grill provides extra milage and power by allowing cool air to reach the carburetor. Connect it with a dryer hose to the tube of the air cleaner. Fiberglass.
GM23-16
|
|
|
Multi Ceramic Paint - AP35
$118.00
[info] [order]
Multi Ceramic coating is heat repellant at its finest.
Roll or brush on the bottom of the fuel tank and engine hatch.
Recommended to prevent vapor lock.
Call for more information and instructions.
AP35
|
|
|
|
|
|
|
Alternator safety Cable GM7-028.1
$25.00
[info] [order]
MUST HAVE FOR FIRE SAFETY. Protects against a high reverse voltage that can damage the alternator light and the Nichrome wire. Any GMC owner can install the ASC by plugging it in between the alternator and the original two-conductor cable.
GM7-028.1
|
|
|
LOWER ALTERNATOR BRACKET GM07-029-11
$14.95
[info] [order]
Allows more room to adjust belts when they stretch.The slot is 3/4 inches longer then the original one. This will also allow you to use shorter belts. This bracket is made of heavy gauge steel.
GM7-029-11
|
|
|
|
|
|
|
|